18 Years Factory Universal Oil Pressure Switch - Pagoda Head Insert Type Water Pump Air Pump Pressure Switch – Anxin

1. Product name: Pagoda Head Insert Type Water Pump Air Pump Pressure Switch, high quality through CE, ROSH certification

2. Pressure control range:：0-10MPA

3. Pressure value: According to customer requirements

4. Interface type: pagoda head interface, can be equipped with air pipe

5. Interface material:Galvanized iron

6. Interface size: 6.35mm diameter

7. Connection mode: insert piece, insert piece can be welded with wire, wire tail can be equipped with connector.

8.Size of inserting piece:6.35mm diameter

9. Working voltage:12/24V

10. Working current:30/50A

This is a pressure switch with a pagoda-shaped joint, and its joint is in a continuous cone shape.So it can better connect with water pipes and air pipes,

This pressure switch is mostly used in small air compressors, small air pumps, and water pumps.Air pipe or water pipe can be installed at its interface, In addition, the inserting part can be connected by soldering wires, and the specified terminal connector can be installed.Of course, if you have high waterproof requirements, you can also add our unique waterproof case, as shown in the figure below

Note: The pressure parameters shown in the picture are for reference only, and all pressure values are customized according to customer requirements.

The pressure switch is a simple pressure control device,When the measured pressure reaches the rated value, the pressure switch can send out an alarm or control signal.The principle is that when the measured pressure exceeds the rated value, the free end of the elastic element is displaced, and the switching element is pushed directly or after comparison to change the on-off state of the switching element to achieve the purpose of controlling the measured pressure.

Every small part of the switch has passed our strict quality control,All products have undergone 5 strict inspections before leaving the factory, including 2 water tests to prevent leakage of the switch, and 3 pressure parameter tests to ensure that all switch pressure values can meet the requirements.